CCNP Collaboration 300-815 Reddit Questions

Page: 10 / 12

Question 40

What are the elements for Device Mobility configuration?

Options:

physical location, device pool, and Device Mobility group

device pool, Device Mobility group, and region

physical location. Device Mobility group, and region

device pool, Device Mobility group, and Cisco IP phone

Question 41

Which two statements are correct with respect to the Client Matter Code setting in the route pattern configuration? (Choose two.)

Options:

The Client Matter Code feature does not support overlap sending because the Cisco Unified CM cannot determine when to prompt the user for the code.

If you check the Allow Overlap Sending check box, the Require Client Matter Code check box becomes

disabled.

If you check the Allow Overlap Sending check box, you can also check the Require Client Matter Code check box.

The Client Matter Code feature does support overlap sending because the Cisco Unified Communications Manager can determine when to prompt the user for the code.

The Client Matter Code has the option to configure Authorization Level such as in the Forced Authorization Code.

Question 42

Refer to the exhibit.

Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider. The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?

Options:

rule 1 /^/+$[^1].*$/ /011\1/

rule 1/^\+1$[2-9]..[2-9]……$$/ /\1/

rule 1 /^$[2-9]..[2-9]……$$/ /\1/

rule 1 /^\+1$[2-9]..[2-9]……$$/ /\0/

Question 43

An SRST site must use pickup functionality on the Chicago remote site to allow the users to take incoming calls. The pickup command is configured under the call-manager-fallback section on the SRST router What are two results of that configuration? (Choose two.)