Your customer’s 802.11n laptops are not able to see the SSID in the 5 GHz band in the conference room. When doing a walkthrough using one of these laptops, you confirm that it is unable to see the SSID in the 5 GHz band in the conference room. When using your own 802.11 ac laptop, you’re able to see the SSID. What is the most likely cause of this problem?
When surveying an existing WLAN infrastructure for a possible redesign, you use two Wi-Fi USB adapters to collect RSSI data and two USB spectrum analysis adapters to collect RF spectrum data. Since your laptop doesn’t have enough USB ports, you use a 4-port powered USB 3.0 hub. What issues could be caused by the use of USB 3.0 that will impact your site survey?
In addition to a copy of your design, which tools should you use to ensure the installation team deploys APs where you have them designed to be located?
When doing some frame capturing over the air during a voice call, you realized that frames on the downlink (from the AP to the client) direction are not being transmitted with the correct UP value for voice frames, but on the uplink (from the client to the AP) direction are being transmitted correctly. What’s the cause of this issue?
What metric implements the simplest algorithm and lowest accuracy in networks requiring locations?
A customer is acquiring a new VoWLAN system to replace their existing wired phone system. When reading about his system’s requirements, you learned that is requires 25 db of SNR to work as expected. After surveying the environment, you discovered that the noise floor is -88 dBm. What should be the minimum RSSI value to meet the system’s requirements?
What is the minimum PoE budget needed on a switch to support 6 (six) APs that can only be powered using IEEE 802.3at if no other details are provided?
Your customer is using PSK as their only authentication. They have an industry requirement to move to a stronger solution. Your recommendation is to move to a certificate-based type of authentication where both the client and server require certificates. Which EAP type would be the best fit?
After designing and deploying a WLAN infrastructure, you realized the CCI is causing poor performance in the 2.4 GHz band. Primarily, you’ve designed the WLAN for 5 GHz and 2.4 GHz as a best effort. You found out that the implementers didn’t follow your guidelines when configuring the WLAN infrastructure. What can you do to minimize as much as possible the CCI impact in the 2.4 GHz band?
TESTED 22 Feb 2025
